Car Alarms: 1991 karr alarm system w/valet switch, karr alarm system, starter wire

Question
My alarm was armed either due to an intrusion or accidental switch or button being pushed. the truck tries to start but wont. The remote is a one button remote, and I also dont know if the switch needs to be up for on or vice versa. The switch I see is in plain view right side  of lower dash area. Is this even the right switch? Yhanks

Answer
It's binary so try this:

In this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

Good luck with it.

ALARMTEK