Car Alarms: car alarm, gmc suburban, chirps

Question
I have a 96 gmc suburban with a rattler remote that wont disarm also killed the engine worst i hav interlock device on this car, after reading some of the stuff in here i did locate the valet switch that has black & grey wires, & the black one is cut. I try to weld it back but didn't work, is there any other suggestion to fix this please help

Answer
Ok then, get over to the local car alarm shop,
or Best Buys will have a valet switch that
will fit for your
alarm.

In the mean time, cut off the switch part,
leaving the 2 wires that were connected, free.

Then twist together, turn on the ignition,
hold both wires to ground until the siren chirps.

That should reset and place the alarm into
over ride for now. Nothing accept the keyless entry
if installed will operate until you repeat the
same steps.

Then get a new switch and you're all set.

Have a good day.
Let me know if you were
successful.

ALARMTEK
CARALARMZ.COM