Car Alarms: chevy s-10 truck, valet mode, passlock 2

Question
TRUCK WAS JUST PARKED AND WHEN I WENT TO START IT WON'T BUT THE ALARM IS BLINKING FAST

Answer
Have a look at www.GMPASSLOCK.com and see if that
applies to your issue (likely).

If after market and you want to try to reset it,
look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE
( if this is a remote starter, the antenna on the
front window glass may also have the over ride
button inset into it.)

This stops the aftermarket alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.

The next step is if wanting to remove it,
got to www.DISARMALARM.com and select that link.

But from the sounds of it, your are going to want to
do a PASSLOCK 2 bypass.

Just experience in this tells me that. Sorry.
But it is doable for about 90.00 :>)

Good luck.

ALARMTEK