Car Alarms: my alarm lights on, not blinking just on, shock sensors, valet mode

Question
Why wont my alarm work ? The Red light is staying on, before it used to blink when i set it letting me and others for that matter know the alarm was set. Now the light just stays on. My panic button works and the lights on my car still flash as though the alarm is setting but it doesnt set at all.. sorry for the limited info dont know wut kind of alarm it is. just know its a two way no screen just two buttons on my keypad has shock sensors and ignition kill any info would be great thanks....

Answer
It appears from your expaination, that the
after market car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
if it also had a 2 way remote starter,
look at the antenna on the windshield for
an inset button. Then press and hold the
button there,(This may be a valet switch as well)
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

(In valet mode, take the vehicle to a local
car alarm shop to evaluate the shock sensor
settings and if all componants are up to snuff.
Makes for a better experience.)

That should do it.
Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM