QuestionI am having some problems in my neighboor hood and would like to set the sensitivity on my alarm higher but i have no clue how to do this, my dad who had the truck before me claimed it was easy. I tryed and can not figure it out any ideas?
AnswerNot certain of the system, but MOST knock/impact
sensors have a wheel inset into it to turn up or down
(counter clockwise is down).
Locate the sensor under the dash and turn down or
simply unplug it. Should be a little oblong box
wire tied up high under the dash, and would
blink when it detects vibration.
Then turn down, check, turn down, check
to see if the level suits your needs,
and you'll be all set.
Good luck.
ALARMTEK
