Car Alarms: hawk ha280 pro car alarm, bmw e34, start car

Question
Hi i have a remote start car alarm HAWK 280 PRO all is wired according to installation guide,
when you first power the alarm ( put the fuse in for the 12v supply ) the remote start works fine but only once, after this if i try to remote start again the ignition circuit works but engine wont crank.
there are 3 main wires as follows-

yellow ( connected to acc from ignition )
blue ( connected to on or power from ignition )
green ( connected to engine start from ignition )

now if i dissconnect the blue wire and try again the engine will crank but not start as there is nothing to power the ignition circuit.

If i take the immobiliser out of the circuit i get the same result.

all the other alarm function's work as they should.

this is for a bmw e34 model

any idea's plz help

Answer
Please go to my forum at www.INSTALLSUPPORT.com
Robert can help you in more depth then I
can go into here.

Just restate this inquiry there.
He's very good about getting back
to folks quickly

INSTALLSUPPORT.COM

If anyone can guide you on this,
he's your man.

Good luck.

ALARMTEK