Car Alarms: car wont start, valet service, car wont start

Question
Hi

I have a Mitsubishi '02.........I assume the alarm installed is after market. the plastic housing of the remote had broke.screws came loose and were lost....had it taped to hold together... I lost the motherboard ........was off to work this morning and found the plastic housing was empty....did all i could do to find the piece.no luck.....anyway now I don't know a dam thing about this alarm I bought this car used...... bottom line is I cannot start my car with out this doo jigger? cannot find cut off switch either........help!!!


Answer
Gotcha, let's put it into valet/service mode,
and try to reset the alarm to default mode.

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode after you determine what alarm you have there,
or get it removed.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM