Car Alarms: Conlog alarm, porsche 994, car alarms

Question
QUESTION: I have a 1985 Porsche 994 that was fitted with a Conlog alarm imobiliser in 1996. I would like to remove it . Is there a wiring digram so that I know which wires on the control box I can join together so that everything works. To many wires to trace them all back.


REPAIR STARTER   ANSWER: If this is a simple starter kill, locate the starter wire under the
dash and remove any device butt connected to it.
I think the wire is RED/BLACK.

See attched file for removing the after market realy and socket.

ALARMTEK

---------- FOLLOW-UP ----------

QUESTION: Hi
Thanks for getting back to me so quick.
It is not just starter interupt but indicators etc. Quite a gagle of wires comming out of the control box.
On it it says Conlog Scimitar PCI (Vesa) if that helps

Answer
No not at all, I am assuming you do not want it,
so the best thing is to remove ALL CONLOG wiring
from where they are interfaced and affect repairs.

Just be methodical, locate the "brain" of the Conlog system
under the dash, and one by one, clip each short and tape off
the wires.

Then repair the starter and you are done.

If uncertain of your skills under the dash, PLEASE by all means
call the local car alarm installer to assist.

Rob Martin
ALARMTEK