Car Alarms: Overide button broken, valet mode, autopage alarm

Question
I have an autopage alarm that has been accidentally put into valet mode.  With the cold season coming, I wanted to have my remote start working properly.  I've read your other answers and when I went to locate the overide button, the red plastic part was broken.  I tried to push it in with a small screwdriver but it won't push down.  I had this alarm installed years ago and have recently moved away from the shop that installed it for me.  Any ideas?

Answer
Ok then, get over to the local car alarm shop,
or even a Circuit City or Best Buys will
have a valet switch that will fit for your
alarm. The are relatively universal.

In the mean time, cut off the switch part,
leaving the 2 wires that were connected, free.

Then twist together, turn on the ignition,
hold both wires to ground until the siren chirps.

That should reset and place the alarm into
over ride for now. Nothing accept the keyless entry
if installed will operate until you repeat the
same steps.

Then get a new switch and you're all set.

Have a good evening.
Let me know if you were
successful.

ALARMTEK
CARALARMZ.COM