Car Alarms: Truck alarm, amp fuse, wire harnesses

Question
I have a 1997 chevy pick up with a champion sercurity system, it keeps drain my batter and it is a keyless entry with remote which do not work, we changed the battieries in both.  It keeps blow  60 amp fuse under the hood, at which time we would have to push the reset button under steerin wheel to crank truck, but then the radio, air, door locks windows qould not work till we replaced the fuse. How can I disconnect this alarm system?
Thank you in advance
Matt Deavers

Answer
Remove it Matt. It is installed incorrectly.
Just take out the Champion brain and wire harnesses
and pitch it.

Once done, repair/tape off any exposed wires.
Go to www.wirewerx.com and get the chart
for the underdash wiring and retrofit the Champion
wiring until extracted.

It's likely the door lock relays are wrong.
But it's best to take out the system and start again.

Also have a read through at www.MRINSTALL.com
for tips/methods on doing this sort of work.

Have a good eve.

ALARMTEK
The WIREWERX