Car Alarms: Falcon predator evo 4 V2, strange readings, evo4

Question
Dear Sir,

I would like to ask for some guidance with some technical difficulties I am experiencing with the installation of the Evo4 V2

The alarm has been fitted the car and appears to have a couple of issues

1   The siren started sounding and cannot be switched off even when pressing all  of the buttons?
2   The LED is on all of the time and does not seem to change?
3   The immobaliser relay has been connected and then the yellow wire from this is connected to the yellow wire (C3-6) from the alarm the car will not start by key or by remote start? Once this connection has been broken then the car starts by either key of remote start? Why is the immobilizer not switching itself off when the car is disarmed?
4   When the system arms you get 1 flash from the hazards but when you disarm you get 3 flashes? I currently do not have any door/boot/bonnet pins connected? I have tested the voltage coming from these wires and seem to have some strange readings?
1.   Blue wire (C3-0) 4.8v
2.   Purple (C3-8) 0 V – the installation manual says that this wire should be a positive feed for interior lights? As mine are –ve triggers I assumed it does not need to be connected?
3.   Green (C3-9) 4.8v
5   C4-2 yellow/black – connection to ACC2 – i do not have this connected as it does not seem to have a function?
6   Once the car has been remote started – and the key is not in the ignition – if you take off the handbrake it stalls but not if you depress the brake pedal? Do i have to have a trigger wire connected to the brake pedal? Which one is this? (C3-5) do i split the feed to both the brake and the handbrake?

Could you please advise on what we should do next?

Has the alarm defaulted to a specific setting where the siren and LED stays on all the time? Have you seen this issue before?

I look forward to your response. I am very keen to have the product working on the car before I go out to my next show. My car has recently won the Autoglym Best in Britian modified car championship. (please see pictures)

Thanks

Anthony Wilson

Tel 01279 713443
Mob 07803 854769


Answer
On this one, the best thing here is
to go to my installers forum at
www.installsupport.com and see if
my resident technicians there can assist
with this project.

I unfortunately don't know the
system you are working with to advise
you properly on it's functions,
features or trouble shooting
information. Better to check with a tech
that might.

Good luck there.

ALARMTEK
CARALARMMAN.COM

PS. MY GUY IN BELFAST COULD ALSO BE HELPFUL.
write to Darren Power: powermyster@hotmail.com

Good luck.