QuestionI have a 2000 Nissan maxima and i recently had an Autopage alarm installed, now randomly the factory alarm sounds when i open the door, using the autopage remote does nothing, im still able to start the car and drive. but the horns beep and the lights flash constantly for a couple minutes then stop. is there a solution to that??
Answerok, get out some basic install tools or get
a friend or a good technician
in there to do this.
Normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. Yours was reset.
Try key in the drivers door, turn left, then
right to diasrm and unlock. If no joy,
you can disable it for good by doing the
following:
The FACTORY ALARM DISARM WIRE IS
orange/blue |-| at pin 30 at the SECU.
The SECU (Smart Entrance Control Unit)
is located to the passengers side of
the steering column.
Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the OEM alarm functions entirely.
However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.
