Car Alarms: anti theft device, infiniti g20, alarmtek

Question
QUESTION: hi, my 96 infiniti G20 will not start,nothing when i turn the key at all,this happened once b4 and it was the security system,but i dont remember what was done,i remember it was pretty easy,ive turned the key left and right to no avail,please help

ANSWER: I need to determine whether it's a factory alarm
issue or, if it's an aftermarket system you are
dealing with.

Is it: Headlights flashing, car horn honking
and a worded SECURITY" light in the dash flashing?
(doubtfull since none of the notes show this
car as having a factory alarm system)=FACTORY

Or,

is it: flashing parking lights,
an LED in the dash area, and a siren
going off?= AFTER MARKET

Let me know more on this to better
advise you on a course of action
to take.

Best Regards,

Robert Martin
CEO/ALARMTEK
CARALARMMAN.com

---------- FOLLOW-UP ----------

QUESTION: none of the above,when i turn the key i get nothing,as if the alarm is activated yet its not going off,however when it did go off,it was horn and lights flashing,then you cant start the car,and yes the dash does have a flashing security light,i m sure this happened once b4 a long time ago but i dont remember what we did to fix it.

Answer
Ok Ms. L, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

A.