Car Alarms: infiniti g20 alarm, infiniti g20, car wont start

Question
I own a 95 Infiniti g20, the locks on my car are corroded since the previous owner never used the keys and just used the keyless entry, i no longer have the keyless entry and was locked out of my car so i had to call a locksmith to break in for me. Ever since he broke in my car EVERY time u open any door the alarm goes off and my car wont start, i've tried just about everything i can to start my car but it just sits there...any suggestions?

Answer
Hmmm, ok this should work.
Sounds like an aftermarket system.

You'll need to set off the alarm for a few seconds.
Then, look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

But if it does work, I'd keep it this way, and
replace the alarm asap with one you know and
understand how it operates for the best overall
experience.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM