Car Alarms: 94 intrepid alarm activated dont know how to turn it off, negative polarity, dash area

Question
Hi, i believe i have a factory alarm system and my dad was messing with my battery and seem to set the alarm on.. and without disabling it completely by splicing the wire how can i reset the alarm. It won't crank and i don't have the keyless remote to reset it manually.  I saw that there maybe an override valet button however i was unable to find it. so I'm wondering if there is another way?

Answer
Ok,
Get out some basic install tools or get
a friend or a good technician
in there to do this.

Normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:

The FACTORY ALARM DISARM WIRE IS
lt.green/orange 20ga |-| in either kick panel.
|- negative polarity|.

Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the OEM alarm functions entirely.

If you have already have an after market alarm
however:

(SIREN & FLASHING PARKING LIGHTS= AFTER MARKET
or is it:
CAR HORN & FLASHING HEADLIGHTS= OEM-FACTORY)

Then look for the over ride/valet button under
the dash area, probably to the left leg region,
drilled into the plastic kick panel.

Then it's: KEY ON, PRESS AND HOLD IN BUTTON FIRMLY
UNTIL THE SIREN CHIRPS ONCE, AND THE PARKING LIGHTS
FLASH. THEN KEY OFF.

This is over ride, and the car should start.
The only thing that would work would be keyless
entry if it is installed. The alarm functions
have been suspended.

Let me know which applied to your issue.

Good luck.

ALARMTEK
CARALARMMAN.COM