Car Alarms: Problem with the cars Autocop device, maruti wagonr, beep beep

Question
QUESTION: Hi! Friends & Experts
I own a maruti wagonR Car, Bought it 2nd hand.using since last 3 months.It came fitted from the previous owner with a Autocop of Silicon make Singapore.
recently within the last week, all of a sudden,the sound from the autocop stopped suddenly, I am able to open & close the car doors with the Autocop but it does not make the Beep beep Single & twice sounds which it used to to make earlier? I do not know the reason why? As if the car does not make the sound Then the purpose of installing the autocop is useless? can u guys pls help me that what could have gone wrong? I am a newbee with cars, Its my 1st car. I have not yet taken it to any sevice station as i have hardly used it for about 500 Kms since i purchased it.If i can solve the problem from you experts guys may be i need not go to a service centre to understand the problem.

The model of the autocop is Silicon autocop is TX-08

Pls advice as to what could be the problem?
Thanks in advance
Tejas

ANSWER: Should be no problem really.
It appears from your expaination, that the
car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM

---------- FOLLOW-UP ----------

QUESTION: Hello Sir
I tried as per your instruction ,but it did not start the alarm,but i observed a small yellow colored wire which is dangling out from the spring switch of the bonnet hood,

Answer
Hmmm, sorry to hear it.
Well then, it's on to removal from
the factory wiring under the dash.

I would suggest you go to the local
Circuit City or Best Buy or any other
local installation shop for inspection/repair
or removal to solve this issue for you.

Good luck with it.

ALARMTEK
CARALARMMAN.COM