Car Alarms: 1997 Honda Accord Alarm Wont Stop, dash area, button spring


Question
I have a 1997 Honda Accord SE with the factory security system.  The alarm system has been going off at all hours for no apparent reason over the last week.  Now it is going off all the time.  I tried to remove the horn/security fuse but then the car won't start. How can I deactivate the security system?  I don't have a remote, as this care didn't come with one when I purchased is 2nd hand. It also didn't have the owners manual to help.  Thank you.

Answer
Ok, Alison, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM