Car Alarms: Nissan Altima 1997, valet mode, nissan altima

Question
I have a Pursuit Car alarm that was installed on the Car. Once the Battery was exhaused when i had the headlights turned on for a long time and when i tried to ignition the car a few times the car did not start but the alarm stopped working. The next morning, I tried the ignition and it started but the Alarm has stopped working and the remoteless entry has been working as usual. please let me know how the issue could be resolved or what could be the issue. Thanks

Answer
Should be no problem really.
It appears from your expaination, that the
car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

If it does not work out this way, you will have
to replace the system with one you know how
to operate and what to expect.

Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM