Car Alarms: magnum auto security system, auto security system, magnum auto

Question
will not allow me to start my car. under the dash it has a spring loaded button & a toggle switch. the LED light is not lit.  please tell me how to get this reset so i can start my jeep. thank you. all help is appreciated

Answer
Standard answer:

Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

This should apply to yours as well.

Good luck.
ALARMTEK