Car Alarms: clifford alarm, clifford alarm, work radio

Question
help my jeep won't start. The alarm went off and then the battery died. I replaced the battery and when i tried to start the jeep neither the dashlights light(engine and break light) or did the engine start. All the electrical components work, radio, lights etc. Do i need to reset the alarm or can i at least dissconct it so i can start my jeep. My wrangler is a 95 and the alarm is a clifford intell 8000
I can't activate the alarm that is also dead.
Thank you
eric

Answer
The Clifford has starter kill apparently.
You will need to reset the alarm.
I do not have that procedure here as
all are different.

Try the forum for that info.  
www.installsupport.com .

Once you get the power going, you will
then be able to put the Clifford into service
mode. Power has to be on to make that happen.

There is no factory alarm by the way.

Good luck.

ALARMTEK