QuestionThe factory alarm system on my 1995 Isuzu Trooper will not turn off using the console switch which is supposed to turn it off. Everytime I exit the car it arms itself and will beep and flash lights if door is opened without remote or if key is not inserted in ignition within about 15 seconds. I have checked the 4 door sensors and the hood sensor and they appear OK. A possibly related issue is that my right turn signal blinker[both dash blinker indicator and tail light itself ] blinks about 3 times as fast as it should but the left one is OK. If there isn't some easy fix that I have not thought of, I would just like to permanently turn off the alarm. How do I do that?
AnswerIf this is indeed the factory alarm,
normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:
The FACTORY ALARM DISARM WIRE IS
orange/black |- negative| kick panel or at alarm.
The alarm module behind the left kick panel.
Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the alarm functions entirely.
However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.
If however it is an aftermarket alarm, see past
postings on going into valet overide mode.
I hope this helps.
ALARMTEK
CARALARMSTORE.com
