QuestionI got a 94 infinity Q45 that recently ran fine until the keys were lost... after many days of searching the ignition was ripped apart and now I can turn the AC power on but no start the stock alarm has me stump... when i pulled the car onto a trailer to move it I got it started i must have picked it up high enough to shut down the system but it is engaged again how do i shut it down without lifting the ass end up every time please help I still don't have any keys either
AnswerThe alarm seems to be in long tamper mode.
You will need to reset, but the aftermarket alarm
seems to be doing it's job.
At least we know it's installed correctly
which is actually a good thing here.
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.
(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)
This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.
At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.
Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.
That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.
If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.
Let me know what happens.
Robert Martin/CEO-ALARMTEK
DELUXESERVICE.com
