QuestionHi
I have recently purchased a cyclone-c300 remote start car alarm and think i have what it takes to install it myself and properly. My car is a VN Calais 1991 model series 2 and is a v6 electronic injection so with me having to roll a wire around the the high coil i cant i have a coil pack, what wire does it wrap aroung then. i have the installation intructions i could e-mail it to you so you can get a better understanding of me explaining this problem and that is with the engine cut off circuit, really i dont understand anypart of of the engine cut off circuit.
AnswerIf the system you have has a
tach monitor wire, which is what this wire sounds
like, locate the wire that reads your engine's rpm rate.
You could even wrap it around a spark plug wire in
some cases. But what you are looking for is the
tachometer wire. Either in the guage cluster,
or near the vehicles coil (n/a here though right?).
Does the system have a tachless or "smart sensing"
way of reading the rpm or induction rate internally
without using the tach wire?
Go that mode if possible for your car.
I sell those here, and might be a another
solution if you can't sort yours out.
www.STARTBYREMOTE.com
For more on this, I'd like to direct you
to my Forum.
Please take this question to the
resident MECP technician at
my online 12 volt installation forum:
www.installsupport.com
His name is Stephan Murphy, (MURPH)
and he may be able to
help further if he get's to read your
inquiry on that site.
Good luck with it.
ALARMTEK
CARALARMSTORE.com
