Car Alarms: Galaxy 5000RS-2W, galaxy 5000rs, wiring schematics

Question
I had a question about the remote start/starter kill relay. There are three different wiring schematics on your web site. I'm not sure which to use.
http://members.tripod.com/~diagrams/starterkill.gif
This first one is the one that was sent with my car wiring info (99 Honda Civic EX 2Dr) When comparing this with the other figures it seems my thick red wire(30 on relay)and the thick white wire (87a) are in the wrong spot. In the figure it specifies the white wire goes to starter but in the back of the instruction book it specifies 30 goes to starter along with the violet wire from the alarm. Are these wires backwards and should I ignore these other two figures?
http://members.tripod.com/~alarmtek/ADDING_STARTER_KILL.jpg

http://members.tripod.com/~alarmtek/SETUP_STARTER_KILL.gif

Answer
Ok, uae this one http://members.tripod.com/~alarmtek/SETUP_STARTER_KILL.gif

and there ae common polls on relays, so there are different set ups that all do the same job. 87 and 30 are common, and 85 and 86 are as well. Interchangeable.

Just use the one for SETUP STARTER KILL.

Good luck.

ALARMTEK