Car Alarms: chapman ultraguard auto alarm, alarmtek, dash area

Question
I have a mercury 1995 sable with a chapman ultraguard
autoalarm system .Yesterday it operated the doorlock but
the car would not startAs per instructions I pressed the
override button and the car started Iwas able to start the car two more times and then it would no longer start even when I repeated the previous proceedure ,eplaced the battery in the remote and tried a jumpstart.The remote still locks and unlocks the car !
Please help if you can.
RUDY  

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

Robert Martin/CEO-ALARMTEK
www.CARALARMINSTALLER.com