Car Alarms: 1994 Vigor, acura vigor, dash area

Question
How do I disarm my 1994 Acura Vigor's car alarm?  It goes off every time I unlock the doors!  If you can be of any help that would be great.

Answer
If this is the Factory alarm locate the green/black
wire |-| in the large harness left of fuse box.
Once located, splice into it and ground to the body
of the car. This terminates the OEM alarm.

However,

If it's an aftermarket system you have there,
put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

I hope this helps you fix this
issue to your satisfaction.

Best Regards,

ALARMTEK
CARALARMCITY.com