Questionwhere can i find wiring diagram for an alarm installed on a used vehicle i purchased the product intermittingly interrupts the starting of the vehicle the only number on the alarm is fccid elvmr5a
AnswerI could not find it in the replacement
database at www.remotesunlimited.com .
So unfortunately, I can't
assist on the make of the system.
As far as trying to get it to go into
overide so the trouble does not
persist until you can replace it with one know how
to operate and trust, try this,
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.
(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)
This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.
At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.
Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.
That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.
If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.
www.USCARALARMS.com is the best
place to get a new system.
Let me know what happens.
Robert Martin/CEO-ALARMTEK
www.CARALARMINSTALLER.com
