QuestionI have an older Viper alarm in my 93 Suburban with a reset(valet) button under dash. Sometimes in won't let me start the truck, nothong. Most the time it works. I try three reset button pushes and and holding it for 45 sec. Then, I walk away for an hour, come back and it might works. How can I fix it or eliminate it through my starter? Thank You.
AnswerOk, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)
This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.
The only thing that will work now on your system,
is the keyless entry if installed.
Just Repeat these steps to rearm your system.
That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.
Let me know what happens.
ALARMTEK
STARTERDISABLE.com
