Car Alarms: car alarm disarming, blinking red light, shock sensor

Question

--from what you indicate, it sounds like my alarm is aftermarket -it has a little blinking red light on the dash (left of the steering wheel) and activation light flash.  ...i'm not sure about the shock sensor though...knowing this, hopefully you can answer my original question.  thanks!

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

Let me know what happens.

ALARMTEK
STARTERDISABLE.com