Car Alarms: Viper Alarm System- I need help!, viper alarm system, toyota corolla

Question
I have a viper alarm system on my 98 toyota corolla. I just bought the car and it came with the alarm system. For a while it worked fine, but today i set the alarm, and when i came back, it would not turn off. I tried buying a new battery for the remote, but that wasnt the problem. Now every time i touch my car the alarm goes off. My boyfriend got under the hood detached the alarm from the battery, but the car is still disabled because of the alarm system. I really need help....

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

Let me know what happens.

ALARMTEK
STARTERDISABLE.com