Car Alarms: prestige alarm, prestige alarm, toyota corolla

Question
Hi i have a problem about my remote control on my prestige alarm for toyota corolla 03 im about to go to my car and when i try to open it with the remote it wont work so i open my car door manually then of course you know the alarm went off so i want to disarm the alarm but i dont know how to do it..i forgot to say the small light n the remote still blinking everytime i press the remote. ist possible that i have a weak battery in my remote, i had my alarm for about a year now thank you..

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

Let me know what happens.

ALARMTEK
WIREWERX.com
KEYLESSCAR.com