Car Alarms: moss security alarm, interior sensors, moss security

Question
i have a moss alarm i have wierd up ive wierd up the ultra sensors in the car and they work i wanted to now how to wire up to the interior lights so when u open the door the alarm goes off i have two green wires and a yellow and they go to wats called  aux   do u now how or where i put these wires to . at the minute it works off the interior sensors but i want it to work off the doors to thanks luke  

Answer
The door pin switches in most cars, are the
door triggers. You will need a (-) monitoring wire
(most are) to determine when power is on the wire.

I don't know the system you are installing so I have
no idea what wire is what there. You would need to
figure that out yourself.

The "AUX" wires usually are (-) outputs
for controling a relay to do trunk pop,
remote start etc...

But in this case, not knowing the vehicle you have,
I'd say that you need to get the (-) door tigger
wire on the "Moss" unit.

If it's a Ford, then you would need a
POSITIVE (+) door trigger.

Most all car alarms will have these
wires.

Good luck on it.

ALARMTEK