Car Alarms: lost alarm keyrings, dash area, oem factory

Question
I have recevied a gift of a 1992 ford ranger extended cab xlt but when I hooked up the new battery to start it the alarm went off and it would'nt let the vehicle turn over so I tried unhooking the alarm that stopped the alarm but the truck still would not turn over I asked but the keyring could not be found. My question is what can I do to get tyhe truck to start? The truck ran when they parked it.

Answer
Ok, don't panic. Try this.
Look under the dash area, maybe to the left
foot area in the plastic, for a button/switch
that does not look like the OEM factory equipment.

Now put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the button until
the installed LED (the blinking light)
in your dash area comes on solid.

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.

Let me know what happens.

ALARMTEK
www.UScaralarms.com