Car Stereos: 2 subs - mono block, kicker amp, two subs

Question
i just purchased  (2)2ohm rockfordfosgate p3d210 i also purshased a kicker amp 08zx750.1ch wut would be the best way to run my subs and how do i connect them (the amp is not 1ohm stable)

Answer
Hi David,

Your subs are a dual 2-ohm voice coil design, so they can be wired in a way that presents a 2-ohm load to the amplifier.  This would be an ideal power/impedance match between the subs and the amplifier.

To this end, you'd want to wire each sub's voice coils in series, then connect the two subs to the amp in parallel.  Here's a link to a diagram (found on JL Audio's support site) that should make it clearer:

http://mobile.jlaudio.com/graphics/Support/Tutorials/wiring_images/DVC_Series_2....

Hope this helps!

Brian