Question2004 Yukon SLT, 5.3 V8. I need to replace the drivers side and the passenger side window switches. How do I remove the door panels for each side?
AnswerHi
PULL UP on the panel..UP not out but UP.....
Here is the procedure from GM SI, same for both sides.
Hope this helps.....FYI the switches are actually the Door Modules and SOME reprogramming MAY be necessary..
Remove the door handle bezel. Refer to Inside Door Handle Bezel Replacement .
Remove the door trim panel upper extension. Refer to Trim Panel Replacement - Upper Extension .
Using a suitable flat-bladed tool, gently pry the manual lock lever from the door trim panel.
Remove the push in fastener at the front edge of the door trim.
Remove the cap covering the screw on the rear edge of the trim panel.
Remove the trim panel screws.
• Remove the screw from within the opening where the manual door lock lever resides.
• Remove the screw from the opening in front of the armrest.
• Remove the screw from the rear edge of the trim panel.
• Remove the screw located beneath the map pocket, if equipped.
Carefully slide the trim panel UP in order to release the retainers from the door.
Disconnect the electrical connectors.
Hope this helps
Pawl