Audio Systems: CAR STEREO REMOVAL, acorn nuts, phillips screwdriver

Question
HOW DO I REMOVE THE STEREO FROM A 2003 4 DOOR HYUNDAI GL

Answer
I'm assuming you have an Accent, you didn't specify what model other than "GL". These instructions are to install a cell bracket, but will work fine.
Step# 01
Open cup holders (2). With Phillips screwdriver will angle through the holder area to get at the (2) screws. Remove screws and set aside.

Step# 02
With hook tool assist starting at the bottom of the radio/climate control/cup holders bezel, pull to release (2) clips at the lower right and left sides of the radio. While pulling out slightly more on the bezel by vents to release (1) plastic clip on each side and (4) at the top of the bezel.

Step# 03
Pull out the bezel enough to get at the (2) screws to the right side of the radio. Remove the (2) screws . Place the A Part of the InDash by PanaVise Mount over the screw holes and replace screws. Make sure the joggle fits onto the radio exactly and tighten the screws.

Step# 04
Replace the bezel starting at the top. Secure the (2) radio clips last. Replace the (2) screws under the cup holders. Install the top part of the InDash by PanaVise Mount with the part number on it with the (2) supplied acorn nuts.