Audio Systems: hook up head unit, torch battery, orange wire

Question
Hello, I have an 84 Cavalier and I labeled all
of the wires,then cut and connected them, head unit would'nt turn on. There is a single connector
with a black and an orange wire. Can you tell me what they are .... remote turn on maybe?

Thanx Clay

Answer
Hi Clay.
So you’re the guy with the 84 cavalier ;-)
I think you have gone about it a bit wrong and miss wired the radio.
Remove the radio and re check the wires on the car, it is best if you solder and tape an ISO DIN connector onto the car's wires so fitting a modern radio is a clunk click job as all radios have this fitting now.
Below is my guide to getting it right, try it.
Good luck Peter


THE FOLLOWING IS THE PROCEDURE I FOLLOW IN A CAR I DON'T KNOW,

You will need;
An AA torch battery
Some paper / masking tape for labels
A pen
Paper to make notes
A 12v test probe, (like a screwdriver with a lead and clip on it and a bulb inside)
(Or a test meter set to 20VDC)

Favourite beverage x 4.

Speaker wires. These are normally twisted together in pairs if you are lucky and are the same colour for each pair but one with a colour trace on, i.e. blue and blue/white, green and green/white. (but not always) Touch a pair across the battery and you will hear a noise on the corresponding speaker, label it (e.g. left rear), continue until all four are identified and labelled.

Drink

Earth one side of your meter or tester to a metal part of the car, probe each wire until you have a wire that is live all the time with the ignition OFF, label this ‘+30’.
Switch on ignition and redo test until you find another previously dead wire now live, this is ‘+15’ accessory.
Switch off ignition and switch on the side / park lights, repeat test until you find a third live ( NOTE, if fitted, not always there), label this ‘dimmer’. Switch off the lights

Drink

You should now have two or three left. One will be earth, (usually black or brown); one could be to an amp and or electric ariel (usually blue or blue/white) and one for phone mute if fitted, (sometimes white but it would go to a phone holder or hands free unit). Connect your DIN plug to the correct wires, test and jobs a good un’.

Two drinks!

DIN connections are.

Speakers

Right rear -,  right front -,   left front -,  left rear-,
Right rear +, Right front +, left front +, left rear +

Power block viewed from cable side

Phone mute (white),/   n/c, /      ariel & amp (blue), /ignition (red)

N/c, / 12vlive, (yellow or orange), / lights, (various colours),/ negative (black)