Audi Repair: Pcodes 1423,1411,1122,1140, throttle position sensor, vacuum hoses


Question
my avant is yr 2000



-------------------------

Followup To

Question -
hi greg,
My A6 Avant 2.8 has...
P1423 EGI functionality test failed, what is this?
P1411 SAI system incorrect downstream flow detected.
P1122 throttle position sensor circuit intermitted, low voltage.
P1140 water in fuel condition.
P0160 O2 sensor bank 2 sensor 2, where is that?

I also have my ABS ligh ON and BRAKE light flashing, i read your previous answer and will try

i guess i will have to dish out alot of money, which i dont have. i dont know anything about the P codes except for the O2 sensor.

please help, thanks
abraham



Answer -
hello
I,m sorry but I'm away from the shop for next 4 days, so I can't check these faults for you. A6- what year?????
P1423, EGR it is for exhaust gas , 2 valve engine had a lot of problems with intake manifold cloging up with carbon where EGR valve is, and this may set this fault.
P1411 seem like bad CAT but I'm not sure till I go back to shop, same with P1122 and P1140.
P0160 is for O2 sensor on left side after CAT. (bank 1 is R/ side, bank 2 is L/ side.
Good luck          pltech

Answer
OK
So, you have 00 A6 with V6 motor
from the top of my head P1423 and P1411 is for secondary air system. There was a lot of problems with vacuum hoses going to combi valves on the back of both heads. Most like it is the hose on the right side , right by the valve. But check your all vacuum hoses. I will do this first, if you find any broken hose, replace it and reset all faults. Vacuum leaks may cause many problems.
good luck          pltech