QuestionI am trying to locate my thermostat in my 2000 Chrysler Concorde 2.7L. I am having a hard time finding it. I have researched the internet and different site are telling me different things. Can you please help me and explain where exactly it is.
AnswerTHERMOSTAT - 2.7L
REMOVAL
Disconnect negative cable from remote jumper terminal
WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.
Drain cooling system.
Remove accessory drive belt for removal of the generator.
Raise vehicle on hoist.
Remove generator attaching bolts. Set generator aside for ease of access to thermostat.
Remove lower radiator and heater hoses from thermostat housing.
Remove thermostat housing bolts Thermostat and Housing - 2.7L Engine
Remove thermostat and housing.
INSTALLATION
Clean gasket sealing surfaces
NOTE: Install thermostat with the bleed valve located at the 12 o'clock position.
Install thermostat and gasket into the thermostat housing.
Install thermostat and housing to cylinder block. Tighten attaching bolts to 12 N·m (105 in. lbs.) Thermostat and Housing - 2.7L Engine
Connect heater and lower radiator hoses. Install hose clamps.
Install generator and attaching bolts.
Lower vehicle.
Install accessory drive belt. Refer to procedure outlined in this section.
Refill cooling system. Refer to Cooling System Refilling.
Connect negative cable to remote jumper terminal.
