Chrysler Repair: trouble code p0344, chrysler sebring convertible, 2006 chrysler sebring

Question
i keep getting the trouble code p0344 on my 2006 chrysler sebring convertible 4 cylinder we have replaced the cam shaft sensor and it worked for like 10 minutes but the car again wont rev past 2200 rpm's and jerks when you get to it and when you turn the engine light off as soon as you rev up to 2200 rpm's it comes back on

Answer
Symptom:
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT
When Monitored and Set Condition:
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT
When Monitored: Engine running or Cranking.
Set Condition: When the failure counter reaches 20. One Trip Fault.
POSSIBLE CAUSES
GOOD TRIP EQUAL TO ZERO
WIRING HARNESS INSPECTION
(K6) 5 VOLT SUPPLY CIRCUIT OPEN OR SHORTED TO GROUND
TONE WHEEL/PULSE RING INSPECTION
CHECKING CKP SIGNAL WITH THE DRBIIIt LAB
CAMSHAFT POSITION SENSOR
(K44) CMP SIGNAL CIRCUIT OPEN
(K44) CMP SIGNAL CIRCUIT SHORT TO GROUND
(K44) CMP SIGNAL CIRCUIT SHORTED TO B+
(K44) CMP SIGNAL CIRCUIT SHORT TO (K6) 5 VOLTS
PCM