Chrysler Repair: 95 Ply Neon 2.0 eng vin-C, paypal account, neon 2

Question
QUESTION: Hello Roland,
About 3 years ago you helped me with this vehicle. I am now getting a code PO352 Misfire on #2 & #3 cyls.It is related to the coil B-circuit.
I am in need of the wiring diagrams for this eng related to all of the sensors,PCM pin voltages ect.
Has new plugs,wires,coil and recent PCM.
Any help would be much appreciated.
Planning on selling the vehicle,so I hate to buy alldata or similar at this time for this vehicle.

Thanks,
GCM

ANSWER: Hi Gary,  
I have the '97 Neon service manual. The 8W-30 section of the manual covers all those systems. It has 12 pages of wiring diagrams and 7 pages of text about the engine control systems. I also have a '98 diagnostic manual where there are 4 pages about the 0352 code. I believe that these are applicable to the '95 model you have.
It costs me 10 cents per side plus the postage so the total would be about $3.50 to get these to you. If you want me to do that then you can put that amount in my paypal account (rfinston@hotmail.com) or if you don't have a paypal then send me eight 44 cent stamps after you receive the pages. But I need a postal mailing address in any case.
Roland

---------- FOLLOW-UP ----------

QUESTION: Hi Roland,
I don't no if I replied back to you. If you could comment on Code PO-352 cyls #2 & #3 are dead.I am still looking for the info you sent me 3 yrs ago. This is on the 95 Ply Neon 2.0 SOHC C-Eng.
If not possible,
AS always,

Thanks much for your time !

Answer
I think I replied, let me look it up:
Here is what I sent you on Saturday but maybe Allexperts didn't tell you about it because I can 'see' that you hadn't read it yet:

Hi Gary,
The troubleshoot involves checking the following;
that the 12v supply from the ASD is present at the driver primary coil (pin 2) when you are cranking it,
that the resistance of the primary winding is below 2 ohms (pin 2 to pin 1, pin 2 to pin 3 for coils 2 and 1 respectively).
check that the driver wire from the pcm to the coil isn't shorted to ground,
check that the driver wire from the pcm to the coil is patent (pin 1 at coil to pin 21, pin 3 at coil to pin 1 at pcm.
.
That is all that is shown.
Roland