Chrysler Repair: Crankshaft pully bolt removal on 2.5L V-6, inpact guns, bolt removal

Question
i have tryed inpact guns and torch and every thing else i can think of and the bolt will not move my gun is a 250 foot pound gun what else can i do

Answer
Hi Skip,
I just got the same question from another 2.5L V-6 owner...how did you get your bolt out? I will pass along any success stories.
Roland


Hi Skip,
You might try some penetrating oil, let it sit, then try rocking the bolt back and forth to break up the rust. Sometimes tightening it a little will break up the friction.  Also try a  longer breaker bar, and I assume you have the pulley wedged tightly. How about wedging the breaker bar against the ground and use the starter motor as an 'impact gun'. Please let me know if any of these are helpful. Best of luck!
Roland
PS Sorry for the delay but I just found your question in the 'pool' to which the other expert had referred it. Please 'rate' my answer, and where you find the question about 'volunteer of the month' please consider a 'yes' if my answer merits that. Thanks