Chrysler Repair: analogue clock in 2001 Chrysler 300M, analogue clock, analog clock

Question
My analogue clock has stopped.  It doesn't go forward or backwards.  I thought it might be a fuse.  It is lit up just doesn't run.  I have looked at both fuse locations (under the hood %26 on the left of the dash board)and can't find the fuse that might be associated with it.  Could you tell me where it might be.  I have a digital clock, but prefer to look at the one at the top of the dash.  If I have to replace it how can I replace it get out of the dash?

Answer
The fuse is the same one for the radio  so unless the radio is inop its good.


REMOVAL
Open hood.
Disconnect and isolate the negative battery remote cable.
Using a trim stick (special tool #C-4755), gently pry out instrument panel air distribution outlet bezel that retains the analog clock.
Disconnect the one wire connector to the clock.
Remove bezel from vehicle.
On the bench, remove two retaining screws to analog clock and remove from bezel (ANALOG CLOCK REMOVAL).