Chrysler Repair: 1999 Town and Country ECM location, powertrain control module, squeeze tabs

Question
Hi-
I need to replace the ECM on my van, but don't know where it is.  I'm going to order a rebuilt ECM with my vans info already programmed so that I can just "plug and play" - can you tell me the location of the module?
thanks!
-pd-

Answer
POWERTRAIN CONTROL MODULE
REMOVAL
Disconnect both cables from battery, negative cable first.
Remove 2 screws holding Power Distribution Center (PDC) to bracket Power Distribution Center Retaining Screws
Remove heat shield from battery Battery Heat Shield
Remove nut and clamp holding battery to battery tray Battery Clamp
Remove battery from vehicle.
Rotate PDC toward center of vehicle to remove from rear bracket PDC Rear Bracket
Pull PDC rearward to remove from front bracket. Lay PDC aside to allow access to Powertrain Control Module (PCM)
Squeeze tabs on 40-way connector. Pull connector rearward to remove from PCM PCM 40-Way Connectors Remove both way connectors
Remove 3 screws holding PCM to fender PCM Removal/Installation
Remove PCM from vehicle.
INSTALLATION
Connect 2 40-Way electrical connectors to PCM PCM 40-Way Connectors
Install PCM. Tighten mounting screws.
Install PDC bracket.
Install battery.