Chrysler Repair: 2004 pacifica consloe, antenna connector, antenna cable

Question
i need to pull the center console on a 2004 pacifica to install an xm radio. are there instructions anywhere?

Answer
Disconnect and isolate the battery negative cable.
Remove instrument panel center bezel (Refer to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - REMOVAL).
Remove radio mounting screws.
Pull radio rearward to gain access to the back of radio (RADIO).
CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

Disconnect the antenna cable by pulling the locking antenna connector away from the radio (ANTENNA TO RADIO).
Disconnect the wire harness connectors from the back of the radio.


REMOVAL
Using a trim stick C-4755 or equivalent, disengage the locking tabs attaching instrument panel center bezel right and/or left side (INSTRUMENT PANEL CENTER BEZEL).
Remove ignition switch bezel.
Remove the instrument panel center bezel(s) from the vehicle.