Chrysler Repair: 95 2.5 V-6 no start, sensor wiring, cam sensor, box connector

Question
Hi!
No more follow-ups, so make a new question.
First. I have no pin 44 on the computer. The pin 44 is emty.
When I check for connection between the orange/white on the 10-pin socket and the feeding cable on the cam-sensor and crenk-sensor I have a clean contact. But....
The orange/white cable is grounded. probobly between the computer and the 10-pin socket. That cable is supposed to have 8V. Is that correct?
Can I use another 8V cable connecting to the orange/white cable where they are splitting one to the crank- and one to the cam-sensor. Whitch pin on the computer gives the 8V signal to the sensors if I dont have pin 44? Can I use another 8V cable and disconect the old one to see if its grounded.
Magnus

Answer
Hi Magnus,
'95 was an early year for the 2.5 V-6. So I checked a '95 Sebring manual and it appears to show a yellow wire on pin 4 of the computer as a 9V supply to the sensors. So check that. It then goes from pin 4 to the junction box connector #4/pin9 (pins 8,9,10 of that connector share the voltage) and out from there on yellow wires 8 (cam) and 10 (crank)to the sensors. While this '95 manual is not a Cirrus manual I am working with (the earliest Cirrus manual I have is a '96 which I had thought certainly applied to your '95) I believe this  Sebring manual may be what is describing your wiring. Let me know.
If the above is not correct, then look over the computer plug to find where the orange/white wire is located. That color code should be correct regardless of the pin to which it is attached.
Roland