Chrysler Repair: dash pad / speed sensors.: Sebring convert, chrysler sebring lxi, chrysler sebring

Question
Hi.My car is a 1995 chrysler sebring LXI 2.5 my first question is how do i locate the input and output speed sensors and how do i remove them. my second question is the dashpad i cant seem to remove it i cant find all the screws ive been trying for three days. Thank you for any and all help.

Answer
Hi Paul,
The speed sensors are on the side of the trans that faces the front of the car. They are about midline height, with one of them near the seam between the engine and the transmission, and the other near the very far end of the transmission, basically on either side of the vertical shift rod. They simply unscrew, after lifting tab and removing the electrical plug, and screw back in to about the torque of a spark plug. They look very similar to one another.
The top pad on the convertible dash is removed by opening the glove box door and then remove the right side end cap of the dash and remove screw at right end. Lift the right rear edge of the pad and lift it to disengage the clips along the rear edge. Procede from right to left, being careful not to damage the edge. Then lift the rear edge and slide the panel rearward to disengage front clips.
To install reverse but be sure the center clips are engaged first Plalce thumb in the VIN opening and pull toward pad to besure VIN is centered in its alignment. If a gap occurs, check the clips which may be damaged and have to be replaced. This is from the '98 convertible manual. The '95 sedan doesn't have a top pad. I don't know which body style that you have.
Roland