Chrysler Repair: 2005 Chrysler Pacifica turn signal, hex head bolts, 2005 chrysler pacifica

Question
How do I change the rear passenger side turn signal on a 2005 Chrysler Pacifica? I've looked all over for a screw in the light housing and everywhere else but can't find it. Thanks in advance for your help.

Answer
Disconnect and isolate the battery negative cable.
Open liftgate, remove two hex head bolts in inner D-pillar (TAIL LAMP UNIT - REMOVE/INSTALL).
Rotate lamp outboard away from vehicle to remove tail lamp forward stud from grommet.
Disconnect electrical connector.
If replacing the tail lamp unit, transfer lamps to new unit.