Chrysler Repair: door repair, door latch, interior door panel

Question
The driver's side door latch seems to be broken.  How can I fix this problem.

Answer
you first need to remove the interior door panel and then put the window in the closed position the latch should have maybe 2 or 3 rods going to it remember where those rods are and unclip the plastic rod keeps from the rods. Then on the outside of you door where the latch is there should be 3 torque bolts something like a T40 maybe remove them and then remove latch and reverse process This is what a manual to a 05 caravan has you do it and it should be similar thanks


REMOVAL
Roll door glass up.
Remove front door trim panel. (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - REMOVAL)
Remove watershield as necessary to gain access to the outside door handle.
Through access hole at rear of inner door panel, disconnect wire connector from power door lock motor, if equipped.
Disengage clips holding linkage to door latch (LATCH ASSEMBLY).
Remove linkages from door latch.
Remove screws attaching door latch to door end frame (FRONT DOOR LATCH).
Remove door latch from door.
INSTALLATION
NOTE: The screws attaching the door latch to the door end frame have nylon patches on the threads. All screws must be replaced when the latch has been removed.

Insert inside handle latch link to door latch and engage clip (LATCH ASSEMBLY).
Place door latch in position on door end frame.
Install screws attaching door latch to door end frame. Tighten screws to 10 N·m (90 in. lbs.) torque (FRONT DOOR LATCH).
Insert other linkages to door latch and engage clips.
Connect wire connector into power door lock motor, if equipped.
Insert a hex wrench through the elongated hole located in the door shut face above the latch.
Loosen allen head screw.
Pull outward on the outside door handle and release.
Tighten allen head screw.
Verify door latch and power door lock operation.
Install watershield and front door trim panel.