Chrysler Repair: 2001 Washer pump change/location, spray washer, hand twist

Question
QUESTION: Hi,
I have 2001 Sebring which won't spray washer fluid, so I'm guessing the pump is shot (no noise when I try spraying).  I've picked up a generic OEM pump but can't seem to find the old unit, if it's located below the reservour, how do I access it? I'd hate to have to pull the bumper off for this one (not that mechanical, but can do minimal stuff)

Thanks in advance!

ANSWER: 2 door  4 door  or convertible sebring?

---------- FOLLOW-UP ----------

QUESTION: Hi Kevin,

Sorry about that, should have included that tidbit!  it's a 4 door.

Answer
REMOVAL
Disconnect and isolate the battery negative remote cable.
Partially remove the bumper fascia as needed to gain access to the reservoir pump. Refer to Frame & Bumpers, Bumpers, Front Fascia, Removal.
Place a drain bucket below the reservoir to catch any washer solvent that may leak out.
Firmly grasping pump by hand twist and pull away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
Remover rubber grommet from reservoir and throw away.